How to Install & Adjust the Peerless Stand for a 42" or Larger Touchscreen

Have more questions? Submit a request

For full assembly instructions, see the following link: Peerless Stand Setup Instructions.

Requirements/Tools Needed:

  • Phillips Head Screwdriver

Getting Started

1. Loosen the bolts indicated below. The left bolt in the image below must be fully removed, the bolt to the right needs only to be loosened. Repeat for both sides of the stand:



2. Pull the touchscreen down until it is at the desired angle, then tighten both bolts into place:

Please Note: The ideal angle will put the left screw in the middle hole (4 of 7)



Articles in this section

Was this article helpful?
0 out of 0 found this helpful